ICON INTERFACE MODULE
SERIAL/ANALOG SPEED CONTROLLER
FOR ICON H-BRIDGE
Get Type Title Description
 
PDF
ICON_IMDS
Datasheet and communication protocol for ICON Interface Module
PDF
AN601
Installing Custom PIC Firmware into the ICON Interface Module
ZIP
AN601
Files Associated with AN601
PDF
AN602
Uploading a Custom Lookup Table into the ICON Interface Module
ZIP
AN602
Files Associated with AN602
ZIP
WIN9x Software
Control software for ICON_IM and ICON_HB (2.9MB)
ZIP
WIN NT/2000 Software
Control software for ICON_IM and ICON_HB (2.9MB)
       
requires ICON_HB 
analog/serial speed controller
up to 12A 40VDC
4.1" x 1.9" footprint
on board F to V converter
 
1 to 49 units
 NA
50 to 99 units $70
100 to 249 units $68
250 to 499 units $65
500 or more call for pricing
Special order of 50+ units required, pricing TBD due to obsolescence.
ICON H-Bridge (ICON_HB), ICON Serial Adapter (ICON_AD), ICON Communication Module (ICON_CM), 12V Active Cooling Kit (12VACK).
   

The ICON Interface Module is a DC motor speed controller designed to interface and control the ICON H-Bridge. The user can send speed control commands via the 38.4Kbps TTL serial interface. The ICON Interface Module will also accept an analog signal in the 0-4.096VDC range for unidirectional, or bi-directional motor speed control.

Test software is available (see below) for use with Windows™ based computers. When used in conjunction with the ICON Serial Adapter (ICON_AD) or the ICON Communication Module (ICON_CM) direct connection to a PC is possible. Additionally the ICON Communication Module may be used to create an RS485 bus for controlling multiple ICON modules with a single serial interface.

The ICON Interface Module has also been designed to function as a programming platform for the ICON H-Bridge. Using the software described previously, and either the ICON Serial Adapter or the ICON Communication Module, ICON H-Bridges may be programmed with user specific fault settings.
GET BUTTON TO THE LEFT OF SELECTION INITIATES DOWNLOAD